Read the card again and see if all is ok for this simple run the software as admin, enter your card in the Hardware and from the software interface press the button Read Card allow it 15/30 sec and the data will show up if all is ok.Press the button EXIT to exit the software, IMPORTANT DON’T PULL OUT THE CARD WHEN THE SOFTWARE IS OPEN EXIT THE SOFTWARE THEN YOU PULL-OUT THE CARD.Now press Valid data a popup will show up with the data you write in the software interface please check if is correct if it is then press Burn-card Button and allow the software 30/1 Min in order for it to burn the data over the EMV Chip.hex format since the POS/ATM is communicating in. Enter The Pin code if you have it (If you are in USA and you want to use the card in POS then the PIN Is not Necessary but if you will like to use the Card in ATM then You need the Pin code).Select The Card Expiration Data (The day is not Important Only the Month and Year).Press the button Check ARQC Key and Check Master Key.From the software Accept EPI MCI Credit Debit.From the software Check the Box Generate a New ICVV For Each Transaction.From the software Press Generate Master Key (This will Generate a Master Key).From the software you can Select Type of Card like Visa, MasterCard etc.įrom the sotware Press the Button Generate ARQC Key (this will generate a unique ARQC Key).Step 3: Select View in New Window Click on View in New Window when prompted by the computer. Step 2: Plug card into USB drive Plug the card reader into any available USB drive on your computer. TIP: The card will only fit in one way, and should slide in easily. On software select your card format and press “Check USD Port” you will be shown a pop once you are connected to com port. Step 1: Insert card into reader Slip the SD card into the SD card reader.Now connect your MCR200 to your laptop and on the software select your hardware and hit “Connect” after being connected and you will be provided with popup notification.
Run the emv.exe as admin on your computer after the installation is completed you will be asked for the license key which will provided with the instructions notepad provided along with the software.